The PowerBox Cockpit SRS is identical in design and construction to the PowerBox Competition SRS, with the addition of one special feature: a freely programmable door sequencer for warbirds or jets.
Features
- SRS: Serial Receiver System provides the facility to use receivers with serial interface: P²BUS, S-Bus*, M-Link, EX-Tele, DSM2/DSMX, X-BUS and HoTT
- Servo-Match function: servo centre, end-points and reverse for 4 channels and 8 servos
- Door sequencer: six freely programmable outputs with set-up assistant
- Unrestricted channel assignment for all PowerBox outputs
- Graphic OLED screen with 128x64 pixels
- Extremely user-friendly menu-based programming using the SensorSwitch
- 11+1 channels
- Signal amplification and interference suppression for all 21 outputs
- Flight recorder, recording of lost frames, fail-safe events and all battery data
- Variable frame rate, range 9ms - 21ms
- 16-bit processor for fast, high-resolution signal processing
- double-regulated output voltages for receivers and servos
- regulated voltage with selection facility, 5.9V or 7.4V
- Connection facilities for P²BUS, S-Bus*, M-Link, EX-Tele, DSM2/DSMX, X-BUS and HoTT downlink bus systems
- Direct transmission of battery voltage and capacity to the transmitter
- Separate voltage and capacity display for each battery
Minimum value memory alerts the user to voltage collapses - Large-area heat-sinks for high regulator performance
- Regulator monitoring, regulator error indicator
- Support for four battery types: LiPo/LiIon, NiMH / NiCd, LiFePo
- Suppression of any servo feedback currents which may occur
- Updateable with PowerBox Systems USB Interface connectors
*only with Teleconverter (Order No. 5600)
Set contents
- PowerBox Cockpit SRS
- 2 patch-leads
- SensorSwitch
- 4 rubber grommets and brass spacer sleeves, factory-fitted
- 4 retaining screws
- Operating instructions in german and english
Operating instructions;
4620_CockpitSRS-CompetitionSRS_en.pdf (powerbox-systems.com)
Technical Data
Operating voltage | 4.0V - 9.0V |
Power supply | 2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH |
Current drain Power-on state | 130mA |
Current drain Standby | 15µA |
Maximum load current | Peak 2x20A |
Drop-out voltage | 0.3V |
Output voltage | 5.9V or 7.4V regulated |
Signal input | serial |
Supported RC systems | PowerBox, Futaba, MPX, Jeti, Spektrum, JR, Graupne |
Receiver redundancy | SRS |
Channels | 11+1 |
Servo sockets | 21 |
Programmable servo outputs | 4 channels, 8 servos |
Servo signal resolution | 0.5µs |
Signal frame rate | 9ms, 12ms, 15ms, 18ms, 21ms |
Screen | OLED 128 x 64 pixels, graphic |
Integral door sequencer | yes |
Supported telemetry systems | P²BUS, S-Bus*, M-Link, EX-Tele, DSMX, X-BUS, HoTT |
Dimensions | 110 x 72 x 24 mm |
Weight | 115g |
Weight Sensor Switch | 15g |
Temperature range | -30°C to +75°C |